Bond-Ace G55


Bond-ACE G55 is a special formulated designed for internal and external plastering works. It's made of re-emulsifiable vinyl acetate homopolymers coalescing with plasticiser agents and added additives for improving the bonding strength of various substrates.

Bond-Ace G55 can be used for interior and exterior plastering, skim coating and renders base treatment, and all cementitious screeds. Applicable to new and old plastered or concrete surfaces.

Surface preparation - The surface must be structurally sound and clean, free of oil, greese, wax, dust, sand, dirt, laitance, paints, efflorescence, curing compounds and loose materials of any type. If the surface is questionable, apply a small test patch of Bond-ACE G55. Allow to completely dry and observe for any signs of lifting, wrinkling, peeling or curling. If these occur, additional surface preparation is recommended.

Recommended cleaning methods are by high-pressure water jets.

Bond-ACE G55 can be applied with paint roller or paint brush or spraying.

Open the original packing and use as it is, do not dilute with water or solvent. Do not add any admixture.

Do not use over water soluble materials such as glue, calcimine, wall paper, casein-based adhesive or where constant moisture is present.

Never shake and box mix as to entrap air bubbles.

Apply Bond-ACE G55 to the treated surfaces evenly. Thin continuous unbroken film is recommended.

Allow Bond-Crete G55 to dry Approximate 30 minutes of drying time, subsequent activities can be carried out. (eg: plastering or tiling) Susequent application of plastering, Skim coating and cement mortar for tilling shall be performed within 72 hours provided Bond-ACE G55 condition is clean, dust free, uncontaminated and intact.

Do not apply to wet surfaces or surfaces where there may be hydrostatic pressure such as retaining walls and swimming pool.

Do not apply to frozen or frost covered surfaces or when temperature is below 50℃ (10℃) is expected to be within 12 hours.

Project Image
Project Image
Project Image
Project Image
Packaging 20 Litres / Pail
Color Blue
Application Method Bond-ACE G55 can be applied with paint roller or paint brush or spraying.
Coverage Approximately (9m2 - 10m2 / litre), depending on the method application, temperatures, porosity and texture of the substrate/ surface.
Drying Time Approximately 30 minutes after applied, depending on the temperature and humidity (18℃ - 45℃).
Open Time 3 Days.
Fire Hazard Non-flammable, VOC compliant.
Toxicity Nil.
Shelf Life 12 Months.
Storage Store in protected areas where ambient temperature is between 50℉ - 90℉ (10℃ - 37℃).